Maytag Washer Locked And Won't Open. How do you bypass a washing. Located on the bottom of the door switch/lock mechanism is a tear shaped tab.
Run a drain and spin cycle. Reconnect power to washer (plug in). If the circuit is broken or has ceased electronically, the maytag washer door may not open or message to start the cycle.
The Release Is Normally Accessible From Below The Door Lock, Or On Some Models, From Inside The Soap Dispenser Housing.
You may also be interested to read the purpose of the lid switch in your washer and signs it could be harmful. If the circuit is broken or has ceased electronically, the maytag washer door may not open or message to start the cycle. Reconnect power to washer (plug in).
If The Washer Has An F8 E1 Error Or Lo Fl Error, The Door Will Be Locked, And The Control Will Be Unresponsive.
To unlock the controls, press and hold the cycle end signal for 3 deliberate seconds or until the control lock light goes out. Press the power button, and the washer will start a drain routine which takes approximately 8 to 10 minutes, during which time the pump will run continuously. If the door or lid won’t open at the end of the cycle, then the lock mechanism may be at fault.
Control Lock Is Turned On.
The door latch assembly might be defective. Consequently, how do i take the lock off my maytag washer? Your maytag washer has a control lock feature to prevent you from using it when plugged in.
To Unlock The Controls, Press And Hold The Cycle End Signal For 3 Deliberate Seconds Or Until The Control Lock Light Goes Out.
Maytag washer door or lid won’t lock if the door lock is defective, the washer door will not latch properly. Inspect the door latch for damage. Because washing machines see a lot of dirt and detergent buildup, there is a chance that something in the mechanism isn’t working properly.
If Your Maytag Washer Is.
The control will not accept any input during this time. The control lock feature locks all functions to prevent an accidental start. If the control locked light will not.